Bowed Wall Repair

If your home is suffering from foundation problems, one of the major issues we face and ultimately repair is bowed basement walls. There are a number of causes to this including; the soil around your home is not compacted to a natural level after the home is built, improper drainage causes water to pool close to the home below grade, and natural shifting of the home over time. As the soil is not properly compacted, it causes what is known as hydrostatic pressure which pushes against the walls of your basement from the exterior. This pressure can cause the walls to bow, buckle, or lean into the home. We have a number of different methods of combating these bowing walls and will choose the correct one depending on the situation your home has.

Wall Anchors

Wall Anchors

Our wall braces, support, and anchors offer a permanent solution for leaning walls in your basement. This common problem is caused by hydrostatic pressure being applied to your foundation walls. Hydrostatic pressure is a result of an excessive amount of moisture in the earth. It can put a lot of force on your walls and cause them to eventually bow inward. Our supports, braces, and anchors will literally brace your wall and can be installed anywhere. We offer reliable, cost-effective solutions which can be installed any time of year with minor digging required.

 

Carbon Fiber Wall Brace

Carbon Fiber Wall Brace

A true structural repair. The surface seal becomes an integral part of the crack injection process. This system revolutionizes concrete crack repair by combining carbon fiber stitching embedded in a hardened epoxy with a structural polyurethane grout injection. The first step is to understand the variables that can cause cracking. Cracking of concrete is a natural consequence of the concrete going from a plastic state to a solid state. This is due in part to stress caused by temperature change and restraint. This is often referred to as drying and shrinkage cracking. Depending on the moisture content, this process is over within a maximum of 3 years. In poured concrete, cracks are usually vertical in nature. The concrete will typically perform the way it was designed after chemically welding the crack back together.

  • A true structural repair. The surface seal becomes an integral part of the crack injection process.
  • All other surface seals add nothing to the crack repair and need to be removed.
  • Can be used for vertical or horizontal crack repair.
  • Dual Surface seal carbon fiber stitching prevents cracking fatigue and distributes load to solid concrete.

Understanding the movement of cracks will increase the success rate of repair. There are 6 ways in which a crack in a below-grade poured concrete wall generally moves:

  1. Tensile/inward: due to lateral loading
  2. Outward: due to shrinkage of soils
  3. Opening: due to thermal changes
  4. Closing: due to thermal changes, i.e. cold, wet, dry, etc.
  5. Shear: due to differential loading
  6. Combination: all of the above conditions, plus the added load of the structure

With our carbon fiber wall brace we can eliminate all crack conditions and re-stabilize any concrete wall.

Steel I-Beams

Steel I-Beams

For the most extreme situations we offer steel I-beams that solidify a basement wall from caving in. These steel pillars are installed from the foot of your floor to the ceiling, attaching itself to the support beam in your basement. This is a surefire way to permanently hold your basement walls in place no matter what soil conditions your home has.

Steel I-Beams on Bowed Walls

Please contact us to learn more about our services, and to schedule a time to get a FREE estimate in your home.

Atlantis Waterproofing & Mold Control
Cookeville
982 Humble Drive
Cookeville, Tennessee 38501
(931)-881-3972 

Write A Review

Chattanooga
7505 Middle Valley Rd. Suite 113
Chattanooga, Tennessee 37343
(423)-424-0893 

Write A Review

Nashville
301 S Perimeter Park Dr Ste 100
Nashville, Tennessee 37211
(615)-420-7953 

Write A Review

Social Links



Write A Review